3D printed chassis weights designed to solve the problem of attaching external weights to chassis where the M-LOK to ARCA rail distance is shorter than normal (Aero Solus and Outlier Modular) while retaining full use of the integrated ARCA rail.
Due to the reduced distance between the ARCA rail and M-LOK slots on chassis like the Aero Solus most chassis weights won’t be compatible when using an ARCA adapter like the Area 419 ARCALOCK Clamp. So the profile of this weight was designed to not interfere with twist knobs on these clamps even when on the clock.
Will work on more standard spacing like those chassis made MDT, MPA, KRG, XLR, etc or M-LOK forends found on AR platforms. Just like any other weight this will help to reduce felt recoil, and tune a rifle’s balance. The extra width these add to a chassis also increases surface contact with a front bag making for a more stable platform.
Features:
Diamond texture top surface for better purchase
Lead shot fill has slight dead blow hammer dampening effect
Integrated recoil lugs
Lid cover screws are same thread and length as Solus adjustable magazine catch screws if you loose one during a match. Can temporarily be used with one lid screw missing in that case.
Tested at multiple +100° F matches
Rad translucent colors (photos incoming)
Weight:
11.29 Oz per set
Material:
PETG+ body
Lead shot fill
Stainless steel black oxide hardware
Tools needed for installation:
1/8” Hex for M-LOK screws
5/64” Hex for lid screws
3D printed chassis weights designed to solve the problem of attaching external weights to chassis where the M-LOK to ARCA rail distance is shorter than normal (Aero Solus and Outlier Modular) while retaining full use of the integrated ARCA rail.
Due to the reduced distance between the ARCA rail and M-LOK slots on chassis like the Aero Solus most chassis weights won’t be compatible when using an ARCA adapter like the Area 419 ARCALOCK Clamp. So the profile of this weight was designed to not interfere with twist knobs on these clamps even when on the clock.
Will work on more standard spacing like those chassis made MDT, MPA, KRG, XLR, etc or M-LOK forends found on AR platforms. Just like any other weight this will help to reduce felt recoil, and tune a rifle’s balance. The extra width these add to a chassis also increases surface contact with a front bag making for a more stable platform.
Features:
Diamond texture top surface for better purchase
Lead shot fill has slight dead blow hammer dampening effect
Integrated recoil lugs
Lid cover screws are same thread and length as Solus adjustable magazine catch screws if you loose one during a match. Can temporarily be used with one lid screw missing in that case.
Tested at multiple +100° F matches
Rad translucent colors (photos incoming)
Weight:
11.29 Oz per set
Material:
PETG+ body
Lead shot fill
Stainless steel black oxide hardware
Tools needed for installation:
1/8” Hex for M-LOK screws
5/64” Hex for lid screws
